Thursday, September 3, 2009


Day 4 of the 30/30 Project


  • You'll need two 4x6 photos

  • I used one sheet of print paper (Sassafrasslass) that came with a
    decorative border & was double sided.  You may need two
    additional sheets if yours is not like this.

  • One sheet of black cardstock

  • One decorative brad

  • Two flower die cuts

Here's how I did my page:

  • Corner round the black cardstock on all four sides.

  • Cut a 4x8 piece of print paper.  Corner round just the bottom
    right side.  Lay your photos & the print paper down for

  • Cut a 1/2 x 12 inch strip of the print paper (my print paper was turquoise on the back side so I used that)

  • Cut off the bar code strip (if using Sassafraslass) or cut a 3/4
    inch strip of another coordinating paper.  (use decorative scissors
    for pizazz!)

  • I had die cut flowers for the page but didn't like my particular
    pattern.  So I traced that flower onto the backside of my printed
    paper & cut a new flower.  There is another flower in the
    center, held together with a decorative brad.  The flower is then
    popped up on a foam square.

  • I adhered my title & then hand wrote "October '08" at the top with a white gel pen.

If you'd like to create your page exactly like mine, there are six (6)
kits available today.  They include everything needed to make this
page, including, foam squares, the decorative brad, two die cut flowers,
the arrow strip & two sheets of QuicKutz Chemistry letters. 
Kits are just $5.  Get yours before they're gone!

No comments:

Post a Comment